Print the Dial enclosure

A two-part bedside stand for the M5Stack Dial v1.1: a base that holds the Dial at an angle, and a faceplate that closes the front. Turn the model below to see both parts.

Drag to turn the parts. The geometry is the repository's own 3MF, converted to glTF without changes.

Get the files

Easiest: open the MakerWorld listing and print its profile.
From the repository: the 3MF files in hardware/ are the same parts.

File	What it is
`enclosure-base.3mf`	Bambu Studio project with both parts placed on one plate and the print profile below. Open this on a Bambu printer.
`enclosure-faceplate.3mf`	The faceplate on its own, geometry only. Use it with any slicer.

Orientation

Base: print on its rear face.
Faceplate: print on its back face.

The project prints both parts in these orientations with supports off.

Settings used

These come from the Bambu Studio project file.

Setting	Value
Printer	Bambu Lab X1 Carbon
Nozzle	0.2 mm
Layer height	0.10 mm
Filament	Bambu PLA Matte
Walls	4
Infill	15% grid
Supports	Off
Brim	Auto

Once printed, follow Build and connect to flash the Dial and point it at Core.

Source reference: Enclosure print instructions · Enclosure 3MF files